|
|
|
Non insulated terminals.
Our terminals are mostly tin plated brass for protection against corrosion.
Where tin plated brass is not available plain brass is used.
The maximum cable size that will fit each cable is stated.
Terminals on this page can be either crimped or soldered.
For crimping use one of these crimp tools: PR4, PR3, MP71, D1.
All terminals can be supplied in bulk packs of 1000 at 25% discount.
Bullets and sockets.
Japanese 3.9mm bullets & sockets. For cables up to 2mm2.

JDS |
|

JDSI |
4.7mm bullets & snap connectors.
 |
|
Bullet. 'W' crimp type.
Use tool D1 to crimp. |
 |
|
Bullet. Solder type.
Tinned brass. |
 |
|
Bullet. Crimp or solder type.
For crimping use SSCT (gives flat crimp),
or TT85 (gives hexagonal crimp). |
Note that the cable size that will fit each bullet depends on the tool used.
This is because the hex crimp(TT85) can only take up a certain
amount of gap as it crimps around the whole circumference,
but the SSCT tool crimps on two sides only. |
Snap connectors for 4.7mm bullets.
Socket & insulation for 4.7mm bullets.
|